10
Using a Speaker Stand
By using a speaker stand, you can mount the KC-150 at the optimal height for use as a monitor speaker or simple PA device.
fig. Caution
●
The KC-150 is designed to be used only with speaker
stands whose dimensions meet the specifications
described below.
Do not use it with a speaker stand that does not meet the
following specifications.
fig.05
fig.06_e
●
When deciding on a stand to use with the KC-150, make
sure to pick one that is capable of supporting its weight.
●
Before use, adjust the speaker stand to a height of 140 cm
(55-1/8”) or less and a leg spread of 120 cm (47-1/4”) or
more, as shown in the figure below.
fig.08\
●
Using a speaker stand that does not meet the
specifications at left or that is adjusted to a height over
140 cm (55-1/8”), or a leg spread of less than 120 cm (47-
1/4”) may result in damage to equipment or injury due to
the stand tipping over.
●
When using KC-150 with a speaker stand, the speaker
stand must be carefully placed so it is level and sure to
remain stable.
●
Cables connected to KC-150 should be given enough
slack to prevent accidents that might result from someone
tripping over them.
●
To prevent accidents due to falls, do not place any object
on the KC-150 when it’s mounted on a speaker stand.
●
Always have at least one other person assist you when
mounting the KC-150 on a speaker stand, or when
adjusting the height of the stand while the KC-150
remains mounted on it.
Leg spread: 120 cm (47-1/4”) or more
Diameter: 3.8 cm
(1-1/2”)
Diameter:
136 cm (53-9/16”)
or more
Leg spread: 120 cm (47-1/4”) or more
140 cm (55-1/8”)
or less
120 cm (47-1/4”) or more
KC-150_e_A4.book 10 ページ ２００５年４月２８日 木曜日 午前９時０分
To Next Page
Loading...
Need help?
General
