11
Getting Started
Turning the Power On and Off
941
NOTE
Once the connections have been completed, turn on power to your
various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
■ Turning on the power
1. Before you switch on the power, turn the
volume all the way down by using the
[VOLUME] slider.
fig.3-05
2. Press the [Power] switch, to turn on the
power.
fig.3-06.e
The power will turn on, and the Power indicator at the
left front of the pt-2700 will light.
fig.00-06.e
After a few seconds, the keyboard will produce sound
when played. Adjust the volume appropriately.
942
NOTE
This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will operate
normally.
■ Turning off the power
1. Before switching the power off, turn the
volume all the way down by using the
[VOLUME] slider.
fig.3-05
2. Press the [Power] switch, to turn off the
power.
fig.3-07.e
The Power indicator at the left front of the pt-2700 will
go dark, and the power will be turned off.
Adjusting the Volume
Use the [VOLUME] slider to adjust the overall volume.
fig.3-08
Setting the Music Stand
Insert the music stand into the two holes as shown in the
figure below.
fig.3-02
NOTE
Before moving the pt-2700, be sure to remove the music stand as a
safety precaution.
ON
Lower position
Power Indicator
Power
OFF
Upper position
To Next Page
Loading...
Need help?
General
