17
Reset to default factory settings (Factory Reset)
This restores all data in the RS-50 to the factory-set condition (
Factory Reset
).
fig.q02-01
1.
Press [PATCH] so it is lit and you are in Patch mode.
2.
Press [UTILITY] so it is lit.
3.
Use PAGE/CURSOR [ ]/[ ] to select “5:FACTORY RESET.”
fig.q02-02_40
4.
Press [ENTER].
fig.q02-03_40
5.
Press [ENTER] again to execute the Factory Reset.
When the display indicates “COMPLETED,” the factory reset operation has been
completed.
If there is important data
you’ve created that’s stored
in the RS-50’s internal
memory, you must note
that all such data will be
discarded when a Factory
Reset is performed. If you
want to keep the existing
data, save it using an
external sequencer (p. 98).
31
2
4, 5
Be sure not to turn off the power while Factory Reset is being performed.
If the power is turned off or interrupted while data is being written to memory,
the internal data may become corrupted.
Press [EXIT] to cancel the
factory reset.
Factory Reset can be
executed not only from
Patch mode, but also from
the Utility functions of
Performance mode (p. 61).
RS-50_e3.book 17 ページ ２００３年１１月７日 金曜日 午後７時１分
To Next Page
Loading...
Need help?
General
