31
Selecting the Pad Type
Setup Guide
4
Strike the pad you wish to set.
The setting screen for the struck pad appears.
5
Select the most suitable trigger type from the following chart for the
pad you are using.
6
Press [INC/+] or [DEC/-] to select the trigger type.
7
Repeat Steps 4–6 to set the trigger type for each pad.
8
Press [KIT].
[KIT] lights, and the Drum Kit screen appears.
fig.P-017ai
9
Strike the pads and press the pedals to check the following.
• Are sounds being played with all pads and pedals?
• Is the right instrument for each pad being played?
If the correct sound is not being played, check the pad settings once more and
refer to “Troubleshooting” (p. 110).
Pad Trigger Type Pad Trigger Type
PD-5 PD7/9 CY-6 CY6
PD-6 PD6 CY-12H CY Type
PD-7 PD7/9 CY-14C CY Type
PD-9 PD7/9 CY-15R CY Type
PD-80 PD80/100 KD-5 KD7
PD-80R PD80R KD-7 KD7
PD-100 PD80/100 KD-80 KD Type
PD-120 PD120 KD-120 KD Type
You can also make the
selection by pressing
[SHIFT] + [ ] or
[SHIFT] + [ ] (Trigger
Select).
These settings apply to
To Next Page
Loading...
Need help?
General
