5
Macintosh Audio Applications CD-ROM
fig.2-4b_30
9.
If the installation was successful, a dialog box like the following appears, click
[Restart]
.
fig.2-5_30
This completes installation of Peak LE.
■
Connecting the UA-30
Before starting up Peak LE, you should connect UA-30 to your computer and to the audio
devices. For how to connect them, refer to the attached leaflet “UA-30 or MA-150U with
MacOS” or the “Getting Started” manual respectively.
■
Starting up Peak LE
1.
In the
“Peak LE”
folder that was created during installation, double-click “Peak LE.”
fig.2-6.e_30
If this screen appears, click
[OK]
and quit Peak LE. Next, go to the
Control Panel
- Memory
, and set “Virtual memory” to “off.” Then, restart your computer.
However, if you are using iMac that are released after the summer of 2000 (iMac,
iMac DV, iMac DV+, and iMac DV Special Edition), then turn the “Virtual
Memory” to “on.”
To Next Page
Loading...
Need help?
General
