3
Panel Descriptions
Name Explanation
12
HDMI 4K OUT connector
This connector can output video up to 4K. Connect a video recording device or display here. Depending on
the setup settings, the signal of the HDMI 4K IN connector can be “thru-output” from here.
HDMI 2.0b 18 Gbps HDCP 2.2 is supported.
13
12G-SDI THRU connector
The video that is input from the 12G-SDI IN connector is output without change from this connector.
A re-clocker is built in.
14
12G-SDI IN connector
This connector can input video up to 4K. Connect a video camera or similar device here.
Input up to 12G-SDI is supported.
15
12G-SDI OUT connector
This connector can output video up to 4K. Connect a video recording device or display here.
Output up to 12G-SDI is supported.
16
REFERENCE IN connector
This connector inputs an analog external synchronization signal.
Black burst/2-value/3-value synchronization signals are supported.
17
REFERENCE THRU/OUT
connector
When this unit is operating with internal synchronization, the internal synchronization signal of the unit is
output as black burst.
When this unit is operating with external synchronization, the external synchronization input is “thru-
output.”
18
DC IN jack
Connect the included AC adaptor to this jack.
You can secure the plug of the AC adaptor by attaching the included DC plug stopper.
* The DC plug stopper can also be attached to the left side of the unit and used as a cable holder.
DC plug stopper
Attaching screw
DC plug stopper
Attaching screw
19
Ground terminal
Connect this to an external earth or ground. Connect this if necessary.
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units before making any connections.
Rear Panel
7
15 17
19
8 5
6
9
11 12 13 14 16 10 18
Screw for
attaching DC plug stopper
Turning the Power On/O
NOTE
This unit does not have a power switch.
We recommend that you use a commercially available power supply control device to control the AC power of this unit.
When powering up
Turn on the power in the order of VC-100UHD
0
source devices
0
output devices.
When powering down
Turn o the power in the order of output devices
0
source devices
0
VC-100UHD.
To Next Page
Loading...
Need help?
General
