Rotax 912 i series Service Instruction

08 February 2024 Current valid documentation see: 74-20-00
Initial Issue www.flyrotax.com Page 1 of 15
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
d07068.fm
SI-912 i-029 / SI-915 i-012
SI-916 i-007
SERVICE INSTRUCTION
Introduction of new double ignition coils and new wiring
harnesses for ROTAX
®
Engine Type 912 i (Series), 915 i (Series)
and 916 i (Series)
ATA System: 74-20-00 Ignition system
1) Planning information
To obtain satisfactory results, procedures specified in this publication must be accomplished with
accepted methods in accordance with prevailing legal regulations.
BRP-Rotax GmbH & Co KG cannot accept any responsibility for the quality of work performed in
accomplishing the requirements of this publication.
1.1) Applicability
All versions of ROTAX
®
engine types:
On engines with S/N higher than those listed above, new ignition coils and wiring harnesses have
already been fitted in serial production.
1.2) Concurrent ASB/SB/SI and SL
In addition to this Service Instruction the following documents must be observed and complied
with:
- in general all relevant Alert Service Bulletins (ASB), Service Bulletins (SB), Service Instructions
(SI), Service Letters (SL), Service Instruction - Parts and Accessories (SI-PAC) with relevance to
perform this maintenance, repair or overhaul task.
1.3) Reason
In the course of further development and standardization, the power connectors on double ignition
coils have been changed from two individual Faston connectors to a single sealed Tyco connector.
In addition, the wiring harness has been changed to accommodate the new Tyco connectors at
each double ignition coil.
1.4) Subject
Introduction of new double ignition coils and new wiring harnesses for ROTAX® Engine Type 912 i
(Series), 915 i (Series) and 916 i (Series).
1.5) Compliance
NONE - For Information Only (It is not mandatory to retrofit non-applicable (see section 1.1)
engines to the new double ignition coils and wiring harness).
1.6) Approval
The technical content of this document is approved under the authority of the DOA ref.
EASA.21J.048.
Engine type Serial number
912 i Series from S/N 10002783
915 i Series
916 i Series

Rotax 912 i series Specifications

General

Brand	Rotax
Model	912 i series
Category	Engine
Language	English