27 March 2017 Current valid documentation see: 12-10-00
www.FLYROTAX.com
page 1 of 11
Copyright - BRP-Rotax GmbH & CO KG. All rights reserved.
d06322.fm
SI-912 i-001R4
SI-912-016R9 / SI-914-019R9
This SI revises SI-912 i001R3/SI-912-016R8 and SI-914-019R8 dated16 April 2015
SERVICE INSTRUCTION
Selection of suitable operating fluids for ROTAX
®
Engine
Type 912 i, 912 and 914 (Series)
ATA System: 12-10-00 Operating fluids
1) Planning information
To obtain satisfactory results, procedures specified in this publication must be accomplished with
accepted methods and prevailing legal regulations.
BRP-Rotax GmbH & Co KG cannot accept any responsibility for the quality of work performed in
accomplishing the requirements of this publication.
1.1) Applicability
All engines of type:
1.2) Concurrent ASB/SB/SI and SL
none.
1.3) Reason
Introduction and release of GAZPROM B-92 and B-92/115. Additional information for coolant.
Change of company name.
1.4) Subject
Selection of suitable operating fluids for ROTAX
®
engine type 912 i, 912 and 914 (Series).
1.5) Compliance
According Maintenance Manual of engine type ROTAX
®
912 i, 912 and 914 (Series), current
issue.
1.6) Approval
The technical content of this document is approved under the authority of DOA ref.
EASA.21J.048.
1.7) Labor time
none.
1.8) Mass data
change of weight - - - none.
moment of inertia - - - unaffected.
1.9) Electrical load data
no change.
Engine type Serial number
912 i (Series) all
912 (Series) all
914 (Series) all
Non-compliance with these instructions could result in engine damag-
es, personal injuries or death
To Next Page
Need help?
General
