11 12
TROUBLESHOOTING GUIDE
Questions Possible causes Answers
- The ON signal will not
turn off immediately
after the coffee cycle
ends.
- As long as the coffee
maker is working
normally, the signal
will turn off a few
minutes after the end
of the cycle.
- Wait for a few minutes
after the cycle ends until
the ON signal turns off
or press firmly on the
luminous switch to stop
your coffee maker.
- The on/off light fails to
come on.
- Appliance is not
correctly plugged in.
- The button was not
activated correctly.
- Plug in properly.
- Press firmly on the
luminous switch.
- Water does not run
through completely.
- Increased noise level.
- The on/off light goes
off while the water is
running through.
- Coffee-maker lined
with scale.
- Descale the coffee-maker.
Subject to modification
ROWENTA THERMOS JUG
● Keeping warm:
Pre-heat the jug for a few minutes
with hot water, then pour out the
hot water.
Your isothermal jug will keep your
drink hot for approximately 4
hours.
Do not use the appliance for soups
or savoury preparations.
● Keeping cold:
Cool the jug with cold water and
empty before filling with a cold
drink.
● Descale your coffee maker after
every 40 cycles.
You can use:
● a packet of limescale remover
diluted in 2 large cups of water.
● or 2 cups of white vinegar or citric
acid.
- Pour the cold descaling solution
into the tank, fit a paper filter in
the filterholder and place the jug
with its lid fitted in the coffee-
maker.
- Start the coffee-maker.
- Stop the appliance once half the
solution has run through and
leave for about an hour. Start the
coffeemaker again and let the
rest of the solution run through.
- After descaling, the appliance
must be operated at least 2 or 3
times with fresh water to rinse.
● The guarantee does not cover
coffee-makers with excessive scale
build-up.
DESCALING
To Next Page
Loading...
Need help?
General
