What to do if the lamination is not clear on my Royal Sovereign RSC-1650C Laminator?
If the lamination on your Royal Sovereign Laminator isn't clear, try increasing the temperature and/or decreasing the speed of the laminator.
How to fix bubbles in Royal Sovereign Laminator?
If your Royal Sovereign Laminator is producing bubbles, try adjusting the tension. You might need more tension on the front right or front left side.
Controls temperature, speed, and machine operation modes.
Using L Wrench and Push-Pull Scale to set front/rear roller pressure.
Checks film feeding angle and center path for proper tension.
Solutions for bubbles based on side (front/back, left/right).
Addresses wrinkles by adjusting tension on front/back, left/right sides.
Improves clarity by adjusting temperature and speed.
Controls temperature, speed, and machine operation modes.
Using L Wrench and Push-Pull Scale to set front/rear roller pressure.
Checks film feeding angle and center path for proper tension.
Solutions for bubbles based on side (front/back, left/right).
Addresses wrinkles by adjusting tension on front/back, left/right sides.
Improves clarity by adjusting temperature and speed.
General| Model | RSC-1650C |
|---|---|
| Category | Laminator |
| Laminating Width | 16 inches |
| Laminating Speed | 10 feet per minute |
| Roller Type | Silicone |
| Power Consumption | 1200 watts |
| Weight | 45 lbs |
| Maximum Laminating Thickness | 10 mil |
| Roller Diameter | 2 inches |
| Take-up Reel | Yes |
| Mounting Capability | Yes |
| Voltage | 110V |
| Dimensions | 20 x 12 x 10 inches |
| Laminating Thickness | 10 mil |
| Warm-up Time | 10 minutes |
To Next Page
