Ryobi AIRgrip MultiTASKit EMM0001 User Manual

14 15
TROUBLESHOOTING
Problem Possible Cause Solution
Vacuum not running Batteries are low
Power is turned off
Replace batteries.
Press on/off button.
Laser line projection is weak Batteries are low Replace batteries.
Laser line is hard to see Light in area is too bright Dim light in the work area or use
laser-enhancing glasses.
Light is not working Power is not “on”
Batteries are low
Press the on/off button.
Replace batteries.
Laser line is not level Leveling bubbles not properly aligned
Level is mounted on base that is not
level
Make sure bubbles are centered in
vials.
Make sure bubbles are centered in
vials after installing multi-function
base onto vacuum base.
Light is dim Batteries are low Replace batteries.
Magnetic tray isn’t holding items Items are not placed on the magnet Put items in the center of the tray
where magnets are located.
Magnetic tray is loose or won’t stay
in position
Handle isn’t tight Rotate the height adjustment screw
clockwise to tighten.
Magnetic tray is too tight/won’t
move
Handle is tight Rotate the height adjustment screw
counterclockwise to loosen.
Helping hand is loose Screws not tight Rotate the locking knob clockwise
to secure in position.
Vacuum base won’t stick to wall Surface is incompatible for vacuum Use rough-surface adaptor on
stucco and textured surfaces.

Ryobi AIRgrip MultiTASKit EMM0001 Specifications

General

Brand	Ryobi
Model	AIRgrip MultiTASKit EMM0001
Category	Laser Level
Language	English