EasyManuals Logo
Home>Ryobi>Laser Level>AIRgrip RLAG113S

Ryobi AIRgrip RLAG113S User Manual

Ryobi AIRgrip RLAG113S
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
WARNING!
READ AND UNDERSTAND ALL IN-
STRUCTIONS. Failure to follow all
instructions listed below, may result in
electric shock, fire and/or serious per-
sonal injury.
CAUTION:
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
CAUTION:
The use of an optical instrument with this
product will increase eye hazard.
The laser guide radiation used in this laser
level is Class II with < 1mW and 630-660nm
wavelengths. These lasers do not normally
present an optical hazard although staring at
the beam may cause flash blindness.
n Avoid direct eye exposure when using
the laser and do not project the laser
beam directly into the eyes of others.
Serious eye injury could result.
n Do not remove or deface any prod-
uct labels. Removing product labels
increases the risk of exposure to laser
radiation.
n Do not place the laser level in a position
that may cause anyone to stare into the
laser beam intentionally or unintention-
ally. Serious eye injury could result.
n Do not operate the laser level around
children or allow children to operate the
tool. Serious eye injury could result.
n Always turn the laser level off when not
in use. Leaving the tool on increases the
risk of someone inadvertently staring into
the laser beam.
n Do not operate the laser level in com-
bustible areas such as in the presence
of flammable liquids, gasses or dust.
n Do not use push pins unless you plan to
affix the base to a soft wood, wallboard,
or other easily penetrated surface. This
could result in injury because the pins are
very sharp instruments.
n Always ensure the laser beam is aimed
at a surface without reflective proper-
ties. Shiny reflective materials are not
suitable for laser use.
n When using the base, always check
to be sure the laser level is securely
seated. Damage to the tool and/or seri-
ous injury to the
user could result if the
laser level falls.
n All repairs should be made by an autho-
rized service representative or the laser
manufacturer.
n Handle the laser level with care. Treat it
as you would any other optical device such
as a camera or binoculars.
SAFETY RULES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ryobi AIRgrip RLAG113S and is the answer not in the manual?

Ryobi AIRgrip RLAG113S Specifications

General IconGeneral
BrandRyobi
ModelAIRgrip RLAG113S
CategoryLaser Level
LanguageEnglish

Related product manuals