1
English
SAFETY INSTRUCTIONS
Please read and observe these instructions before using
the device.
Ŷ Before using the device, check that the mains cable
and mains plug are not damaged.
Ŷ The device must not be damp, neither should it be
used in a damp environment.
Ŷ Do not use the device if it has suffered any heavy
shock or jolting, or is damaged in any other way.
Ŷ Due to the heat generated during charging, the battery
charger should not be operated on a combustible
surface or in an inflammable environment.
Ŷ Do not cover the ventilation slits.
Ŷ Never disassemble the device yourself.
Ŷ Pull the plug of the battery charger out of the socket
when it is not in use or when cleaning it.
Ŷ Only use extension cable that is approved and
technically in perfect condition.
Ŷ During operation, provide sufficient ventilation.
Malfunction during charging can be caused by storing
and operating in places where the temperature
H[FHHGV Û& WKLV VKRXOG EH DYRLGHG %DWWHU\
charging in closed cupboards and near heat sources
(radiators, bright sunshine) causes heat to accumulate
and can damage the device.
Ŷ If the battery is not going to be used for a longer period,
remove the battery from the charger and disconnect
the charger from the power supply.
Ŷ Protect the battery contact to avoid short circuit caused
by metallic object that can cause fire or explosion.
Ŷ Only charge original recommended batteries.
Ŷ If the power cord is damaged, it must be replaced by
an authorised service center in order to avoid a hazard.
WARNING
Do not recharge primary cells (non-rechargeable).
Damage to property
Mains voltage must correspond with the voltage
specifications on the device.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING
7RUHGXFHWKHULVNRI¿UHSHUVRQDOLQMXU\DQGSURGXFW
damage due to a short circuit, never immerse your
WRROEDWWHU\SDFNRUFKDUJHULQÀXLGRUDOORZDÀXLGWR
ÀRZLQVLGHWKHP&RUURVLYHRUFRQGXFWLYHÀXLGVVXFK
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries or
conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps
or tape. Do not transport batteries that are cracked or
leaking. Check with the forwarding company for further
advice.
SPECIFICATIONS
Battery
Pack
Voltage
Charger
Input
Battery
type
Battery
Capacity
No. of
Cell for
Battery
BPP-1413
14.4 V
220V-240V,
50Hz AC
only
Ni-Cd
1.3 Ah 12
BPP-1415 1.5 Ah 12
BPP-1417 1.7 Ah 12
BPL-1414 Li-Ion 1.4 Ah 4
To Next Page
Loading...
Need help?
General
