EasyManuals Logo
Home>Ryobi>Battery Charger>OP403

Ryobi OP403 User Manual

Ryobi OP403
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 — English
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
Charging RYOBI 40 Volt Lithium-ion batteries
Charging small (up to 2.1 Amps) USB electronics
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
CHARGING
See Figures 1 - 2, page 8.
Battery packs are shipped in a low charge condition.
Therefore, you should charge them before first use. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger to
your nearest repair center for electrical check.
Charge time varies and is dependent upon the amp hour
capacity of battery pack.
Turn the battery pack upside down so that the latch faces
up.
Attach the charger to the battery pack by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the charger onto the battery pack.
NOTE: The connection between the battery pack and
charger may feel slightly loose. This is normal and does
not indicate a problem.
Press down on the charger to be sure contacts on
the battery pack engage properly with contacts in the
charger.
The latch should snap into place to ensure charger is
correctly connected.
Connect the power adaptor to a power source and then
the cable to the charger.
NOTE: Make sure the power supply is normal household
voltage, 120 volts, AC only, 60 Hz.
Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
If any parts are damaged or missing, please call 1-800-860-4050 for assistance.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ryobi OP403 and is the answer not in the manual?

Ryobi OP403 Specifications

General IconGeneral
BrandRyobi
ModelOP403
CategoryBattery Charger
LanguageEnglish

Related product manuals