6
SPECIFICATIONS
Oscillating Range 5/8 in. (15.9 mm)
Oscillations Per Minute 58 OPM
Spindle Size 1/2 in. (12.7 mm)
No Load Speed 2000 RPM
Input 120 Volts, 60 Hz, AC only, 3.5 Amps
Weight 49 lbs. (22.2 kg)
UNPACKING
INFORMATION
We have shipped the oscillating spindle sander
completely assembled and ready to use with a 1 in.
(25.4 mm) rubber spindle, 7/8 in. (22.2 mm) upper
spindle washer, 1 in. (26 mm) throat plate, and 80 grit
1 in. (25.4 mm) sanding sleeve installed on the spindle.
■ Remove the loose parts from the box. Make sure
that all items listed in the loose parts list are in-
cluded.
■ Remove the packing materials from around the tool.
■ Lift the tool carefully from the box and place it on a
level work surface.
NOTE: The sander is heavy. Ask for assistance if
necessary.
■ Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts,
and satisfactorily operated the tool.
■ If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
■ Inspect all parts carefully to make sure no breakage
or damage occurred during shipping.
WARNING:
If any parts are missing do not operate the tool until
the missing parts are replaced. Failure to do so
could result in serious personal injury.
LOOSE PARTS LIST
1. Sanding sleeves, 50, 80, 150 grit (17)
2. Rubber spindles (4)
3. Throat plates (5)
4. Upper spindle washers (2)
5. Wrench
1
2
3
4
5
To Next Page
Loading...
Need help?
General
