10 — English
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Line will not advance when using
the auto-feed head
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Lubricate with silicone spray.
Install more line. Refer to Line Replacement
earlier in this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to
Line Replacement earlier in this manual.
Grass wraps around boom
housing and string head
Cutting tall grass at ground
level.
Cut tall grass from the top down to prevent
wrapping.
Motor fails to start when switch
trigger is depressed.
Battery is not secure.
Battery is not charged.
To secure the battery pack, make sure the
latches on each side of the battery pack snap
into place.
Charge the battery pack according to the
instructions included with your model.
CALL US FIRST
For any questions about operating or maintaining your product,
call the Ryobi® Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
To Next Page
Loading...
Need help?
General
