10 — English
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
String will not advance when using
the auto-feed head:
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Lubricate with silicone spray.
Install more string. Refer to String Replacement
earlier in this manual.
Pull string while pressing button.
Remove string from spool and rewind. Refer
to String Replacement earlier in this manual.
Grass wraps around boom
housing and string head
Cutting tall grass at ground
level.
Cut tall grass from the top down to prevent
wrapping.
Motor fails to start when switch
trigger is depressed.
Battery is not secure.
Battery is not charged.
To secure the battery pack, make sure the
latches on each side of the battery pack snap
into place.
Charge the battery pack according to the
instructions included with your model.
CALL US FIRST
For any questions about operating or maintaining your product,
call the Ryobi® Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
To Next Page
Loading...
Need help?
General
