11 - English
OPERATION
QUESTIONS AND ANSWERS
QUESTION ANSWER
What is the Primary
receiver?
In any Cluster, there is a single Primary receiver, and all of the other receivers in the Cluster
follow its behavior. You can control the entire Cluster by operating the Bond Button of the
Primary (a receiver must have a physical Bond Button in order to become the Primary).
How do I “uncluster”
several receivers?
Do the Make a Cluster of Receivers procedure once for each receiver (omit Step 3). This
gives each of the receivers a functioning Bond Button, and each of them will thereafter oper-
ate independently.
What are some tips for
making Clusters?
Each step in the Make a Cluster of Receivers procedure has a 10-second time limit. For
example, when you see the Primary’s Indicator start to flash Red, you have 10 seconds to
power on the next receiver. When that receiver’s Indicator starts to flash Red, you have 10
more seconds to power on the next one, and so on.
Why does only one
of my Bond Buttons
work?
When you make a Cluster from several receivers, the first one powered on in the Make a
Cluster of Receivers procedure becomes the Primary of the Cluster. Only the Primary’s Bond
Button works because a Cluster uses just one Green List (the Primary’s Green List). The Bond
Button of the other receivers will work only for the Mute / Unmute function (3 Clicks).
Can any group of
receivers be made into
a Cluster?
No. The receivers must be members of the same product family. If they are not, the Make a
Cluster of Receivers procedure won’t work. This is because only receivers that were designed
to work together (as a single product) can be made into a Cluster.
MAINTENANCE
WARNING:
Always remove the battery pack from the product and
disconnect from the power supply when you are assem-
bling parts, cleaning, or when not in use. Removing bat-
tery pack or unplugging extension cord will prevent acci-
dental starting that could cause serious personal injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
To Next Page
Loading...
Need help?
General
