Safety
4
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 5.
1. Keyless chuck
2. Torque adjustment ring
3. Quick mode selector Two-speed gear train
4. LED Indicator (Fuel gauge)
5. )RUZDUGUHYHUVHEXWWRQ
6. Switch trigger
7. Battery port
8. Handle, insulated gripping surface
MAINTENANCE
Ŷ When servicing, use only original replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Ŷ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
Ŷ Do not attempt to modify this tool or create accessories
not recommended for use with this tool.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
LED INDICATOR
Battery charge LED colour
66% - 100% Green + Yellow + Red
33% - 66% Yellow + Red
< 33% Red
NOTE: If only the red LED indicator is illuminated, it
means the battery power is low. The battery needs to be
recharged.
BATTERY OVERLOAD PROTECTION
This tool is designed to protect the battery from overloading.
When overloading is detected, the tool will automatically
switch off. To resume operation, switch the tool off and
on again. If the tool fails to operate, it means battery pack
is discharged and should be recharged in a compatible
charger.
SYMBOLS
Safety alert
V Volts
Revolutions per minute
Direct current
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Please read the instructions carefully
before starting the machine.
Recycle
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or
retailer for recycling advice.
To Next Page
Loading...
Need help?
General
