39 - English
TROUBLESHOOTING
Problem Cause Solution
Saw does not make accurate 90˚ or
45˚ cuts.
Positive stops inside cabinet need
adjusting (Bevel Cuts).
Miter gauge is misaligned (Miter Cuts).
Adjust positive stops.
Adjust the miter gauge.
Height/bevel adjusting hand-wheel is
hard to turn.
Gears or screw post inside cabinet are
clogged with saw dust.
Clean the gears or screw post.
Saw does not start. Motor cord or wall cord is not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breaker.
Have the cord or switch replaced at
your nearest authorized service center.
Blade makes poor cuts. Blade is dull or dirty.
Blade is wrong type for cut being made.
Blade is mounted backwards.
Clean, sharpen, or replace blade.
Replace with correct type.
Remount blade.
Blade does not lower when turning
height/bevel adjusting handwheel.
Locking lever is not at full left position. Move locking lever to left.
Motor labors in rip cut. Blade not proper for rip cut. Change blade; rip blade typically has
fewer teeth.
To Next Page
Loading...
Need help?
General
