12 — English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Handle not in position. Handle adjustment knobs and/or handle
lock clips are not secured.
Make sure handle adjust knobs are
fully seated and handle lock clips are
fully closed.
Snow blower not starting. Battery is low in charge.
Start button is not depressed.
Charge the battery.
Press start button.
The motor is on but the impeller does
not turn.
The drive belt is worn or broken. Have the drive belt replaced by an au-
thorized service center.
After passing, the snow blower leaves
a layer of snow on the ground.
The impeller/scraper mechanism is
worn.
Have the impeller/scraper mechanism
replaced by an authorized service
center.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi Help Line!
To Next Page
Need help?
General
