To Next Page

To Previous Page

Page 2

Look for this symbol to point out important safety precautions. It means attention!!!

Your safety is involved.

The following recommended accessories are current and were available at the time this manual was printed.

■ 5-1/2 in. (140 mm) Thin Kerf Blade

■ Optional Rip Guide

Your circular saw has been shipped completely assembled

except for the blade. Inspect it carefully to make sure no

breakage or damage has occurred during shipping. If any

parts are damaged or missing, contact your nearest Authorized

Service Center to obtain replacement parts before attempting

to operate saw. A blade, blade wrench, and this operator's

manual are also included.

■ Table of Contents ............................................................................................................................................................2

■ Accessories .....................................................................................................................................................................2

■ Unpacking....................................................................................................................................................................... 2

■ General Safety Rules ......................................................................................................................................................3

■ Specific Safety Rules .................................................................................................................................................. 4-5

■ Important Safety Instructions For Charger .................................................................................................................. 5-6

■ Symbols ...........................................................................................................................................................................7

■ Features ..........................................................................................................................................................................8

■ Operation ................................................................................................................................................................... 9-18

■ Maintenance ................................................................................................................................................................. 19

■ Battery Pack Preparation For Recycling ...................................................................................................................... 19

■ Parts Ordering / Service ............................................................................................................................................... 20

TABLE OF CONTENTS

ACCESSORIES

UNPACKING

The operation of any power tool can result in foreign objects being thrown into your

eyes, which can result in severe eye damage. Before beginning power tool operation,

always wear safety goggles or safety glasses with side shields and a full face shield

when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or

standard safety glasses with side shields. Always use eye protection which is marked

to comply with ANSI Z871.1.

WARNING:

If any parts are missing, do not operate this tool until the

missing parts are replaced. Failure to do so could result