RT500RF INSTRUCTION MANUAL
5
INSTALLATION
Please read the important safety information at the start of this
manual before you begin to install the device.
The RT500RF Control Centre is easily installed using the Industry
Standard back plate supplied with the unit – this is used purely for
mounting purposes, as no wiring is needed for the Control Centre.
The back plate can be mounted directly to the wall surface.
The ideal position to locate the RT500RF Control Centre is about
1.5m above floor level. It should be mounted in a location where the
thermostat is accessible, reasonably lit and free from extremes of
temperature and draughts. Do not mount the thermostat on an
outside wall, above a radiator or in a location where it may be
subjected to direct sunlight.
To ensure trouble free operation of the Radio Frequency (RF) signal,
always ensure that the programmable thermostat is mounted away
from any possible sources of interference (such as radios, TV sets,
computers, etc.), and is not mounted on or in close proximity to
large metal objects. Installing the RT500RF in enclosed areas such as
cellars and basements is not recommended.
CONNECTING THE RT500RF RECEIVER
NOTE: All electrical installation work should be carried out by
a suitably qualified Electrician or other competent person.
If you are not sure how to install this programmable thermostat
consult either with a qualified electrician, heating engineer or your
boiler / heating system supplier for advice on how to continue.
To Next Page
Loading...
Need help?
General
