Name: Samson C03
Brand: Samson
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Using the Optional SP01 “Spider” Shock-Mount

SP01

SHOCK MOUN

THREADED

COLLAR

THUMB

SCREW

00 -10dB-10dB

THREADED

COLLAR

00 -10dB-10dB

Using the Optional SP01 Shock-Mount

For additional isolation, the C03 can be fit-

ted on the optional SP01 “Spider” shock

mount. Follow the steps below the to

install the SP01.

• First, screw the SP01 shock mount

onto your mic stand or boom arm. If

you’re using a US 5/8” mic stand or

boom, remove the Euro adapter.

• Remove the C03 swivel mount by

rotating the threaded collar counter-

clockwise as shown in figure 1.

• Install the C03 into the SP01 by fitting

the microphone into the center of the

web, positioning the C03 onto the bot-

tom mounting plate.

• Secure the SP01 by reinstalling the

threaded collar, rotating clockwise

until tight. (Figure 2)

•Now, loosen the thumb screw to

adjust the angle of the microphone

and position the C03 to the desired

location. Once set, tighten the thumb-

screw to secure the microphone in

place.

Note:

Be careful not to cross thread

or over tighten the threaded collar or

thumb screw.

Questions and Answers:

Need help?

Do you have a question about the Samson C03 and is the answer not in the manual?

Samson C03 Specifications

Microphone Specifications