You must select the Cool mode if you wish to adjust the:
Cooling temperature
Fan speed when cooling
1
If necessary, press the button.
Result:
The operation indicator on the indoor unit lights up.
The air conditioner starts up in the mode selected
when the unit was last used.
The indoor unit beeps.
IMPORTANT
The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2
If the is not displayed at the top of the remote control,
press the button on the remote control one or more times until it
appears.
Result:
The indoor unit beeps each time you press the button.
The air conditioner runs in the Cool mode.
Note
You can change modes at any time.
3
To adjust the temperature, press the button one or more times until
the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result:
Each time you press the button:
- The temperature is adjusted by 1°C
- The indoor unit beeps
The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
4 Select the fan speed by pressing the button one or more times
until the required setting is displayed:
Automatic (rotated :
)
Low
Medium
High
Maximum
Result:
Each time you press the
button, the indoor unit beeps.
5 To control the direction of the air flow, refer to pages 14.
Cooling Your Room
To Next Page
Loading...
Need help?
General
