User’s Manual 15
Setup
1. Connect the power cord for your monitor to the power port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet.
2. Connect the signal cable to the video port on your computer, video board, video card, or graphics
card.
3. If you are using a Macintosh computer, connect the cable to a Macintosh adapter, and set the
pins on your adapter (Adapter not included). A PC-compatible computer does not need an
adapter.
Note:
Turn on your computer and monitor. If your monitor displays an image, installation is
complete.
Connecting Your Monitor
To Next Page
Loading...
Need help?
General