14
OTHER FUNCTIONS
Function of fault alarm
Fault
Cause of fault
Indication
Alarm of the
buzzing sound
Stopping alarm
Alarm for
water inlet
Entering water less than 16
minutes, reset water level.
Alarm for
opening lid
Open the LID after starting
the delay time. Open the LID
when the washer is spinning.
Imbalance alarm
Checked imbalance for the
third time.
Drain alarm
After draining for 4 minutes,
does not finish to drain.
The buzzer goes
on buzzing for
10 seconds. If
the fault is not
solved , buzzes
again for 10
seconds in every
16 minutes.
Open the lid to
deal with faults,
then close the lid
to stop the alarm.
Automatic power shut off
1. If the machine is not started within 10 minutes after powered on, it will power off automatically
2. If the machine is not powered off until the buzzer sounds 6 times after the operation, it will power off
automatically
Adjusting for unbalance
1.If the laundry is placed uneven before spinning, it causes excessive vibration of spinning. The washing
machine has a function of adjusting unbalance. During cycles, the washing machine always inspects running
state. If the spinning vibration is too big, the washing machine automatically starts the adjusting program to
balance.
2. If the washing machine detects the unbalance even after the adjustment, it will alarm.
E1
E2
E3
E4
15
POWER PLUG
POWER PLUG
POWER CORD
POWER CORD
POWER CORD
CONTROL PANEL.
LID
WASHER
WASH/SPIN
WASH/SPIN TUB
WASH/SPIN TUB
WASH/SPIN TUB
WASH/SPIN TUB
WASH/SPIN TUB
WASH/SPIN TUB
1.the appliance is not intended for use by young children or infirm persons without supervision.
2.Young children should be supervised to ensure that they do not play with the appliance.
To Previous Page
Loading...
Need help?
General
