...,,--
SPECIFICATION
TUNER SECTION
Reception frequency
FM . . . . . . . . . . . . 87-5 -108 MHZ
AM . . . . . . . . . . . . 522- 1710kHz
CASSETTE DECK SECTION
Track system . . . . . . .
Frequency response . .
Signal to noise ratio . .
Wow & Flutter . . . . . .
Tape speed . . . . . . . .
Fast forward and
rewind time . . . .
CD PLAYER SECTION
Channels . . . . . . . . . .
Sampling frequency . .
Pick-up . . . . . . . . . . . .
Frequency response . .
Wow&Flutter . . . . . .
AMPLIFIER SECTION
Output power . . . . . . .
Bass expander . . . . . .
,’ Input . . . . . . . . . . . . . .
outputs . . . . . . . . . . .
OPERATING THE
4-track, 2 channel stereo
80
6iZ -13.5 kHz
50 dB
0.15 % (WRMS)
4.75 cm I sec.
Approx. 110 sec. (C-60)
2 channel stereo
44.1 kHz
optical 3-beam semiconductor laser
20
HZ -20 kHz
Below measurable limits
5WX2
(at 4 ohms, 10% distortion)
+ 8 dB (100” Hz)
VIDEO :300 mV / 50k ohms
SPEAKERS :4 ohms
PHONES :8-32 ohms
GENERAL
Power requirements . .
Power consumption . .
Dimensions (WX H x D)
Weight . . . . . . . . . . . .
-.
d
. . . .
AC :230-240 V, 50 tiz
. . . .
38 W
. . .
Approx. 270x283x211 mm
. . . . Approx. 3.7 kg
WIRELESS REMOTE CONTROL
Power requirements . . . . . . 2 “AA” batteries
Dimensions (W x H x D) . . . Approx. 40x 168x 18.5 mm
Weight . . . . . . . . . . . . . . . .
Approx. 48 g (without batteries)
SPEAKER SYSTEM
Type . . . . . . . . . . . . . . . . . . .
Unit used . . . . . . . . . . . . . . .
Maximum power-handling
capacity . .
Nominal impedance . . . . . . .
Dimensions (W
x H x D) . . . .
Weight .. . .. . . . . . . . . . . . .
2 way bass reflex
Woofer :12 cm cone type
Tweeter :2 cm piezoelectric
10 W (peak)
4 ohms
..
Approx. 180x285 x211 mm ““
Approx. 1.4 kg (per speaker)
Specifications subject to change without notice.
.... .. .. . . ... .
. .. .. . ... . ... ..
RESET SWITCH
This CD / TUNER and TAPE DECK/ PRE-AMPLIFIER unit is provided with a reset switch on the rear panel. The reset switch
serves to initialize the microprocessor in the each units which controls the CD, TUNER, TAPE DECK and etc block. If the unit
is to be serviced or key input is not acknowledged even when the CD / TUNER, TAPE DECK and etc. operation buttons are
pressed, press the RESET switch and initialize the microprocessor following the step below.
1. Disconnect the AC power cord from the power outlet.
2. Keep the RESET switch depressed for 60 seconds.
(The backed up electrolytic capacitor is discharged by keeping the RESET switch depress.)
3. Reconnect the AC power cord to the power outlet.
4. Press the CD / TUNER, TAPE DECK and etc. operations, and check their operation.
s
I
-1-