-7-
GENERAL OPERATION
TURNING THE POWER ON
........................................ 1
Install the front panel and press the POWER button
when ACC is on.
TURNING THE POWER OFF
...................................... 1
Press the POWER button
to stop the current operation.
The button dims when the power is off (ACC on).
ELECTRONIC CONTROLS
......................................... 2
Push the AUDIO button
, then Push the AUDIO button
to select the audio functions as shown in the
table below.
Turn the VOL knob
to adjust the selected function ; bass, treble, balance, fade, or volume.
SOUND EFFECT BUTTON
......................................... 3
Press the SND Button
for less than 1.5 second.
Each time the button is pressed, the function changes as shown below.
MODE
bAS(bass)
TRE(treble)
bAL(balance)
FAd(fader)
V(volume)
Turn left (Min)
Down -5
Down -5
Left L9
Rear R9
Down 0
Turn right (Max)
UP +5
UP +5
Right R9
Front F9
UP 35
1 FLA (FLAT) 2 ROC (ROCK) 3 CLA (CLASSIC) 4 POP (POPS) 5 JAZ (JAZZ) 6 HIP (HIP HOP)
1 2
5 3 6 784
While no other mode is displayed, the VOL knob function as a volume control.
Note
ECD-T1820_E.fm Page 7 Tuesday, December 14, 2004 8:33 AM
To Next Page
Loading...
Need help?
General
