EasyManuals Logo
Home>Sanyo>DVD VCR Combo>HV-DX2E

Sanyo HV-DX2E User Manual

Sanyo HV-DX2E
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
INTRODUCTION
9
Rear Panel
AUDIO
OUT
VHS IN+OUT/DVD OUT
DVD/VHS
OUT
RF.OUT
AERIAL
VIDEO OUT
R
COAXIAL
L
DIGITAL
AUDIO OUT
DVD EXCLUSIVE OUT
EURO AV1
AUDIO/
VIDEO
EURO AV2
DECODER
Caution
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the DVD+VCR.
COAXIAL (Digital audio out jack)
Connect to digital (coaxial) audio equipment.
AUDIO OUT (Left/Right)
Connect to an amplifier, receiver or stereo system.
AERIAL
Connect the aerial using this jack.
VIDEO OUT
Connect to a TV with video inputs.
EURO AV1 AUDIO/VIDEO (VHS IN+OUT/DVD OUT)
Connect to your TV set or another video recorder.
RF.OUT
Connect to your TV using this jack.
Mains lead
Connect to a power
source.
EURO AV2 DECODER
Connect to another video recorder.
Remote Control Operation Range
Point the remote control at the remote sensor and press
the buttons.
Distance: About 7m (23ft) from the front of the
remote sensor
Angle: About 30° in each direction of the front of the
remote sensor
Remote control battery installation
Detach the battery cover on the rear of
the remote control, and insert two R03
(size AAA) batteries with and
aligned correctly.
Caution
Do not mix old and new batteries. Never mix different
types of batteries (standard, alkaline, etc.).
AAA
AAA
Note
The EURO AV2 socket is used for signal input only.
DECODER is shown but this DVD+VCR does not have
it.

Table of Contents

Other manuals for Sanyo HV-DX2E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo HV-DX2E and is the answer not in the manual?

Sanyo HV-DX2E Specifications

General IconGeneral
BrandSanyo
ModelHV-DX2E
CategoryDVD VCR Combo
LanguageEnglish

Related product manuals