12
Operation with the Remote Control
Unit
1. Automatic Operation
The air conditioner calculates the difference between the thermostat setting and
room temperature, and automatically determines the mode to operate under
cooling or heating. Then, the air conditioner continuously operates under the
mode selected at initial operation.
Check that the circuit breaker on the power panel is turned on.
Once mode is selected and the unit is preset by following the steps below, you
can have the air conditioner automatically bring the room to the desired
temperature simply by pressing the ON/OFF operation button.
STEP 1 Press the MODE selector button to .
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation button again.
• To change the temperature setting; press the temperature setting buttons and
change the setting to the desired temperature.
STEP 2
STEP 1
NOTE
NOTE
OI-809-12-EG
01_KMHS1872_EN.fm Page 12 Monday, July 9, 2007 4:39 PM
To Next Page
Loading...
Need help?
General
