13
OPTIONAL COMPONENTS
Temperature recorder
WARNING
Disconnect the power supply plug before attaching the temperature recorder or it may cause
electric shock or fire.
An automatic temperature recorder is available for this freezer as the optional component. The type of
the recorder is MTR-G85. Consult Sanyo sales representative or agent for the recorder installation.
Following shows the installation procedure.
1. Remove four screws (shown by arrows) on the front
panel and take the panel off. By removing seven
screws, take off the left side panel. Then take off the
cover for the recorder mounting space by removing four
screws. (Fig. 1)
2. As shown in the Fig. 2, insert the temperature
recorder to the mounting space and fix it to the back
side of the front panel by using the recorder fixture
enclosed with the recorder.
3. Take off the recorder sensor cover in the chamber
(bottom left side) by removing two screws. Then
remove the rubber cap and insulation covering the
access port. (Fig. 3)
Fig. 2
Fig. 1
Cover
Side panel
Fig. 3
Recorder
sensor cover
Sensor port
To Next Page
Loading...
Need help?
General
