www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
37
16. Troubleshooting
Fault Possible cause Remedy
Blade dissolves after
-
gine
Tighten the right hand thread nut
Engine will not start Failure mains fuse Check mains fuse
Defective extension cable Replace extension cord
Connections on motor or switch not in
order
Motor will not work,
the fuse is active
Cross section of the extension cable does
see „Electrical connection“
Change saw blade
Fire marks on the
cutting surface
Blunt saw blade
sharpening service) or replace
Wrong saw blade
Change saw blade
negative consequences for the environment and hu-
that are often contained in electrical and electronic
resources. You can obtain information on collection
-
-
-
Old devices must not be disposed of with house-
hold waste!
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
and electronic equipment.
To Next Page
Loading...
Need help?
General
