www.scheppach.com
24
|
GB
• Push the choke lever (13) back after starting the en-
gine.
Warm state
•
•
•
•
start, pull on the handle again.
m ATTENTION!
for a maximum of 5 minutes.
Allow the power generator to run for a short time with-
•
• Close the fuel valve (11).
Connection to alternating current (AC)
• Allow the generator to run for a few minutes before
connecting electrical devices.
•
connecting more electrical devices than the device
can handle.
• -
nected to the generator.
Tip
power consumers, please remember to connect the one
the lowest starting current last.
Overload indicator (6)
The overload protection becomes active if the power
socket (4).
•
•
devices to the rated power.
• -
tion is detected, remove it.
• Put the device back into operation.
• Fill storage tank with fuel.
• -
wise.
Recommended fuel
rating of 91 or higher is required for this engine.
m
-
tem.
m Refuel in a well-ventilated area with the en-
gine stopped. If the engine was in opera-
Never refuel the engine in a building where the
sparks.
When
-
vere injuries.
•
•
•
Earthing (Fig. 1)
charging. To do this, connect a cable on one side to the
earth terminal (8) of the power generator and on the oth-
er side to an external mass rising pipe (e.g. rod earth).
10. Start up
m Attention!
Always make sure the device is fully assembled
before commissioning!
m ATTENTION!
back.
Cold state
•
•
•
as it will go.
•
•
-
gine does not start, pull on the handle again.
To Next Page
Loading...
Need help?
General
