www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
11
• All parts of the universal machine stand, in particu-
order to guarantee trouble-free operation.
• Keep the universal machine stand out of reach of
children. Store the device in a location that is inac-
cessible to unauthorised persons and children.
m Attention!
universal machine stand, the respective machine-spe-
-
Read all of the instructions for the electric power tool that
must likewise be observed.
6. Technical data
Dimensions
935 - 1945 x 545 x
805 -915 mm
Table height 763 mm
Height of the side expansions 805 - 910 mm
Spacing of the supports
min. / max
935 - 1945 mm
150 kg
Weight in kg ca. 9,8
7. Before starting the equipment
-
livered the device.
8. Attachment and operation
-
piece supports as follows:
8.1 Erecting the universal machine stand
(g. 3 - 4)
on a workbench such that the frame legs (A.1) point
upwards.
Press the spring pins (K) and fold out the frame leg.
Once the spring pin latches into the intended position,
the frame leg is locked.
Repeat this process for the other frame legs.
Set the universal machine stand down on its feet.
Electric power tools without suitable mounting holes
-
with the universal machine stand.
-
versal machine stand before starting them up.
The universal machine stand is also designed as a
workpiece support when working with mitre saws,
scroll saws, circular table saws, and other similar
electric power tools.
The maximum workpiece length is 3 m.
(e.g. a roller trestle) in order to prevent longer work-
pieces tilting.
Attention: Ensure that the workpiece support is se-
cure and not tilted!
Do not use the universal machine stand as a ladder
screws are tightened before use. Electric power tools
on this device shall not exceed an overall height of
-
turer is not responsible for the resultant damages,
the user bears this risk alone.
Please note that our equipment has not been de-
signed for use in commercial, trade or industri-
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Safety information
• -
tion with suitable electric power tools!
• Check the universal machine stand for damage
each time before use. Electric power tools shall not
be mounted or operated on damaged support arms
/ crossbars.
• Electric power tools must be bolted to the support
arms / crossbars and be secured on the universal
machine stand!
• -
cure when setting it up.
•
standing position when working.
• Do not overload the universal machine stand! Do
not use the universal machine stand for purposes
for which it is not intended.
• -
versal machine stand as well as the use of unap-
proved parts is forbidden.
To Next Page
Loading...
Need help?
General
