SEA BEYOND INT’L T-REX User Manual

BRAKE ADJUSTMENT GUIDE
Often the disc brakes on our gas scooters will require adjusting. Do each step below and
check and see if the brakes are adjusted correctly after each step. There is no need to
complete all the steps if only one or two adjustments fix them. Usually the first
Step One:
This usually fixes any problems.
First turn the smaller hex bolt
circled above using a 2.5mm hex
wrench. There are two hex heads on
this same screw circled above. The
smaller 2.5mm one is hidden deep
beneath the larger 5mm one.
Step Two:
Usually Step One fixes most
problems, the next three steps help
fine tune the brakes. Loosen the
cable holder using a 5mm hex
wrench. Then use some pliers to
hold the cable, then move the arm
towards the engine, and retighten
the 5mm hex screw.
Step Three:
Turn the knob circled by hand as
shown in the picture.
Step Four:
Turn the silver piece circled above
by hand, then lock it in place by
turning the black piece until it is
closest to the hand lever just like in
the picture above.
4

SEA BEYOND INT’L T-REX Specifications

General

Brand	SEA BEYOND INT’L
Model	T-REX
Category	Scooter
Language	English