7. COIN HANDLING
7-1 INSTRUCTION FOR ELECTRONIC COIN COMPARATOR TYPE
A. REMOVE THE PLASTIC COIN FROM COIN SLOT, REPLACE WITH THE DESIRED
TOKEN OR COIN INSIDE THE SPRING TENSIONED COIN HOLDER.
B. LOOSEN BOLTS AT THE BACK OF COIN ENTRANCE. USE THE DESIRED COIN
DIAMETER TO ADJUST SPACE AT THE BACK OF COIN ENTRANCE. AVOID ERROR
CAUSED BY LARGE DIAMETER TOKENS.
C. ADJUST FOR GAME MAIN BOARD PULSE RATE NEEDS. CHOOSE COIN LONG
SHORT AND FAST SLOW THREE PHASE SWITCH (TIMER SWITCH)：30MS IS SHORT
FAST SIGNAL BEST FOR MACHINES THAT HAVE HIGH POWER AND REQUIRES THE
INSERT OF COINS QUICKLY, 50MS IS MIDDLE SIGNAL, BEST FOR ORDINARY
MACHINES (IF NOT SPECIAL CIRCUMSTANCE, THE MACHINE USUALLY CAN USE
THIS PHASE). 100MS IS LONG, SLOW SIGNAL, BEST FOR MACHINES THAT DO NOT
NEED COINS INSERTED QUICKLY.
D. VR COIN CHOICE SENSITIVITY ADJUSTMENT. ANTICLOCKWISE ADJUSTMENT
（—），ACCEPT SMALLER AREA OF COIN TOLERANCE，COIN TYPE FILTRATION
WILL BE MORE RESTRICTED.
Wiring：
Grey
Red -DC+12V
White –COIN signal
Code Table
Black-Grounded
Grey
You can get this game at www.magic-play.eu
You can get this game at www.magic-play.eu
To Next Page
Loading...
Need help?
General
