Specification changes (removal of equipment, conversion and addition) not designated by
SEGA are not allowed. The parts of the product include warning labels for safety, covers for
personal protection, etc. It is very hazardous to operate the product by removing parts
and/or modifying the circuits. Should doors, lids and protective parts be damaged or lost,
refrain from operating the product, and contact where the product was purchased from or
the office herein stated. SEGA shall not be held responsible for any accidents, compensation
for damage to a third party, resulting from the specifications not designated by SEGA.
Ensure that the product meets the requirements of appropriate electrical specifications.
Before installing the product, check for electrical specifications. SEGA products have a
nameplate on which electrical specifications are described. Ensure that the product is
compatible with the power supply voltage and frequency requirements of the location.
Using any electrical specifications different from the designated specifications can cause a
fire and an electric shock.
Install and operate the product in places where appropriate lighting is available, allowing
warning labels to be clearly read. To ensure safety for the customers, labels and printed
instructions describing potentially hazardous situations are applied to places where
accidents can be caused. Ensure that where the product is operated has sufficient lighting
allowing the warnings to be read. If any label peeled off, apply it again immediately. Please
place an order with where the product was purchased from or the office herein stated.
When handling the monitor, be very careful. (Applies only to products with monitors.) Some
of the monitor parts are subject to high tension voltage. Even after turning off the power,
some portions are still subject to high tension voltage sometimes. Monitor repair and
replacement should be performed only by those technical personnel who have knowledge
of electricity and technical expertise.
Be sure to adjust the monitor properly. (Applies only to products with monitors.) Do not
operate the product leaving on-screen flickering or blurring as it is. Using the product with the
monitor not properly adjusted may cause dizziness or a headache to an operator, a player,
or the customers.
When transporting or reselling this product, be sure to attach this manual to the product.
In the case where commercially available monitors and printers are used in this product, only
the contents relating to this product are explained herein. Some commercially available
equipment has functions and reactions not stated In this manual. Read this manual together
with the instruction manual of such equipment.
Descriptions herein contained may be subject to improvement changes without notice.
The contents described herein are fully prepared with due care. However, should any
question arise or errors be found, please contact SEGA.
INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION
Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately after
transporting to the location. Nevertheless, an irregular situation may occur during transportation.
Before turning on the power, check the following points to ensure that the product has been
transported in a satisfactory status.
Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet?
Are casters and adjusters damaged?
Do the power supply voltage and frequency requirements meet with those of the location?
You can get this game at www.magic-play.eu
You can get this game at www.magic-play.eu
To Next Page
Loading...
Need help?
General
