sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, first slide up the dust cup
release button, then tilt the dust cup, and lift to
remove.
Pre-Motor (foam and felt):
With the dust cup removed, take out the foam and
felt filters, and rinse them with water. Tap loose dirt
o filters between washes asneeded.
Post-Motor (HEPA):
To access the HEPA filter, press the button under
the filter cover and lift o the cover. Pull out the
HEPA filter and rinse it with water only. Allow the
filter to air-dry completely before reinstalling.
To reinstall, place bottom of dust cup into pod and
then tilt the dust cup until it clicks into place.
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To remove collected debris from Lint Screen, press
top release button and lift handle to access screen.
Gently brush lint screen to clean.
CLEAN HEPA FILTER
EVERY YEAR
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters to air-dry for
at least 24 hours before reinstalling them to prevent liquid from being drawn into electricparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
NOTE: The pre-motor filters should be replaced
every 2.5 years. The post-motor filter should be
replaced every 3 years.
To Next Page
Loading...
Need help?
General
