AZ910UKSeries_MP_QSG_190510_MV2
For questions or to register your product, contact us at
0800 862 0453 or visit us online at sharkclean.eu
©2019 SharkNinja Operating LLC. All rights reserved. Made in China. SHARK, DUOCLEAN and LIFT-AWAY are registered trademarks
of SharkNinja Operating LLC. POWERED LIFT-AWAY is a trademark of SharkNinja Operating LLC.
QUICK
START
GUIDE
Please be sure to read the enclosed Shark instructions prior to using your vacuum
Use this Quick Start Guide
to start using your new
vacuum’s great features.
Register your vacuum at
registeryourshark.com
AZ910UK SERIES
Access brushroll and Soft Roller
1. Use a coin to unlock the 3 locks on the
bottom of the floor nozzle, a portion of
the base is removable to allow for better
access to the brush roll and exposure to
the airway. Shine a torch from the bottom
to check for possible blockage in the
airway.
2. Clear away any objects or debris.
3. To reassemble, replace base by lining it
up along the front of the nozzle. Push
down to snap into place. Lock the 3
locks. If Brushroll Indicator Light isn’t
green and headlights are flashing, check
again that both sides of lid are locked in
place.
MAINTENANCE
Empty dust cup after each use
Empty
Release
TIP:
Wash filters to keep the
suction strong.
Rinse filters and allow to air-dry
completely. Tap loose dirt
from foam filters as needed
between washes.
See enclosed instructions for
complete details on removing
and cleaning filters.
Brushroll Maintenance
Carefully remove any debris that may be
impeding the brushroll.
Soft Roller Maintenance
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
DUOCLEAN
®
POWERED LIFT-AWAY™ WITH
ANTI HAIR WRAP TECHNOLOGY
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the
airway, then remove any blockages.
@sharkcleaninguk
@sharkcleanuk
@sharkcleanuk
To Next Page
Need help?
General
