18sharkclean.eu
MAINTAINING THE SOFT ROLLER
1
Open the brushroll garage by sliding both
release buttons away from you, toward the
back of the floor nozzle, then lifting off the
garage. Lift out the Soft Roller by the tab on
the right side. Clean off any string, carpet
fibres, or hair that may be wrapped around
the Soft Roller, and remove debris from the
roller housing.
2
Wash the Soft Roller as needed, using only
water. Air-dry completely for at least 24 hours
before returning it to the brushroll garage
.
3 Reinsert the Soft Roller by sliding it into
the front of the floor nozzle until it clicks
into place. Close the brushroll garage by
inserting the tabs on the lid into the slots
on the floor nozzle, then pressing down
on the lid, above the headlights, until both
sides click into place.
CHECKING FOR BLOCKAGES:
Handheld, Wand, and Floor Nozzle
1 Turn off vacuum and remove Lithium ION
Power Pack.
2 Remove the wand from the handheld
vacuum and check all intake openings to
the dust cup.
3 Remove the floor nozzle from the wand
and check the wand for blockages.
4 Tilt neck of floor nozzle back to straighten
the airway to remove blockages.
To Next Page
Loading...
Need help?
General
