sharkclean.comsharkclean.com
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
Detach wand from floor nozzle and handle, and
check both ends for blockages.
Detach wand from floor nozzle, tilt nozzle neck
back, and check opening for blockages.
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
Slide the Soft Roller access button forward to
release the Soft Roller.
Hand wash the Soft Roller as needed. Use only
water, and allow it to air-dry completely for at
least 24 hours. Reinsert the Soft Roller in the
front of the nozzle until it clicks into place.
CLEANING THE SOFT ROLLER
MAINTENANCE
SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, clear them from the
brushroll.
NOZZLE MAINTENANCE
To access the nozzle hose, open the locks on the
bottom of the nozzle. With a coin, turn the locks
counterclockwise, then lift the cover and clear any
blockages.
NOZZLE HOSE BLOCKAGE
HOSE BLOCKAGE WAND BLOCKAGE
POD BLOCKAGE
HANDLE/HOSE BLOCKAGE
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut o power to
the vacuum and remove the cord from the
brushroll or nozzle.
1. DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around sharp
corners.
5. DO NOT leave the cord near heated
surfaces.
CORD MAINTENANCE
To Next Page
Loading...
Need help?
General
