Sharp Carousel R-1511 Cooking Guide

24
CHARCOAL FILTER
Charcoal Filter, Sharp part number RK-240 which was
installed in your oven, is used for nonvented, recircu-
latedinstallation.The ltershouldbechanged every
6 to 12 months depending on use. See page 6 for
ordering information.
1. Disconnect power to the oven at the circuit breaker
panel or by unplugging.
2. Remove the three louver mounting screws and
push down carefully on the tab at each end of the
louver to disengage it. (See illustration.)
3. Pull the louver away from the unit.
4. Changethecharcoallter.
5. Carefully push the louver back into place (engag-
ing both the bottom and top tabs) and replace the
screws removed in step 2.
Light cover
Screw
Light bulbs
REPLACING PARTS
LIGHT BULBS
1. Toreplacelightbulbs,rstdisconnectpowertothe
oven at the circuit breaker panel or by unplugging.
2. To release cover, remove the screw on the light cover.
(See illustration.)
3. Replace light bulbs with equivalent watt bulb
available from your Sharp Authorized Servicer or
parts distributor. Bulbs are also available at most
hardware stores or lighting centers. DO NOT USE
A BULB LARGER THAN 30 WATTS.
4. Close light cover and secure with screw removed in
step 2.
CAUTION: Light cover may become very hot. Do not
touch glass when light is on.
Louver
Charcoallter
(white side faces front)
Top tab
Bottom tab
Screw
Screw
Screw
TINSEB391WRRZ_rev 2_R-1514.indd 24 4/19/17 2:27 PM

Sharp Carousel R-1511 Specifications

General

Brand	Sharp
Model	Carousel R-1511
Category	Microwave Oven
Language	English