To purchase contact: noitaroproC scinortcelE prahS
Customer Assistance Center
Sharp Plaza Blvd
Memphis, Tennessee 38193
Phone: 1-800-BE-SHARP (237-4277)
G R O U N D I N G I N S T R U CTI O N S
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk
of electric shock by providing an escape wire for the electric current.
3-Prong Plug
Grounding Pin
3-Prong Receptacle
Ground Receptacle Box
consult a qualified electrician or service person.
2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal injury resulting
4
from failure to observe the correct electrical connection procedures.
Radio or TV Interference
evaworcim eht taht kcehc ,VT ro oidar ruoy ot nevo evaworcim eht yb desuac ecnerefretni yna eb ereht dluohS
oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check
position and signal of receiving antenna.
U N P A C KIN G I N S T R U C T I ONS
Latches
Hinges
Oven Cavity
Door seals and sealing surfaces
Unpacking and Examining Your Oven
Carefully remove oven from carton. SAVE THE CARTON AS IT MAY MAKE
INSTALLATION EASIER.
Remove:
WARNING – Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
Check Installation Instructions for proper location for the power supply.
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected
electrical supply. It is recommended that a separate circuit serving only the oven be
provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a
wall receptacle that is properly installed and ground
ed. DO NOT UNDER ANY
CIRCUMSTANCES CUT OR REMOVE THE GROUNDING PIN FROM THE PLUG.
Notes: 1. If you have any questions about the grounding or electrical instructions,
O P T I O N A L A C CESS O R I E S
Check the oven for any damage, such as misaligned or bent door, damaged
door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door.
If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER.
See Installation Instructions for more details.
1. all packing materials from inside the oven cavity; however, DO NOT
REMOVE THE WAVEGUIDE COVER, which is located on the ceiling in
the oven cavity. Check to see that there are Installation Instructions, Wall
Template and Top Template. Read enclosures and SAVE the Operation
Manual.
2. the feature sticker from the outside of the door, if there is one.
Charcoal Filter (RK-220). This is required when hood exhaust is recirculated. See Charcoal Filter on page 27. To
order filter replacement, if dealer does not stock this item, it can be ordered by calling 1-800-BE-SHARP (237-4277).
To Next Page
Loading...
Need help?
General
