Applications 79
4. Press the digit keys to specify the musical scale and
rest.
For details on specifying the sound level and rest,
see “To Specify the Musical Scale and Rest” on
page 80.
5. Press P or R to specify the types of musical
notes or rest.
For details on specifying the musical notes and rest,
see “To Specify the Types of Notes and Rests” on
page 80.
6. Press d after inputting one note.
Input the next note after the cursor moves to the
right.
7. Repeat steps 4 to 6 to input notes.
When entering notes, you can do the following:
• Press to play back all input notes.
• Press [Options] and select:
“Play bef. cursor” to play back notes up to the cursor
position.
“Select Part” to select another chord.
“Set Tone” to set or change the tone using different
instruments. (p. 81)
“Set Strength” sets the strength of the tone. (p. 81)
8. When you finish inputting, press [Options] and
select “Save”.
9. Select “Save to My Items”.
Note
• The volume varies depending on the Multimedia
Volume settings (p. 95). The sound is deactivated
when “Multimedia Volume” is set to “Silent”.
• If the capacity or memory in Saved Sounds becomes
insufficient, the message, “Maximum capacity : 200
Not registered.” or “Not registered. Memory full.” is
displayed. The screen returns to step 9. Try again
after deleting unnecessary data (the current melody
will be lost).
• Melodies consisting of too many short notes
(semiquavers and triplets) cannot be played back in
step 8 and the following message is displayed: “Can
not play due to too many notes per sec.” The screen
returns to step 5.
The message “Can not save due to too many notes
per sec.” may also be displayed, and the screen
returns to step 5.
Reduce the number of melodies, replace short notes,
cancel triplets, etc. to remedy.
To Next Page
Loading...
Need help?
General
