97
10. SMART TV TROUBLESHOOTING
1. TV cant connect to wi- network
Steps to x this issue:
• Set on your wi- router/access point WPA or WPA2 encryption. WEP is not supported.
• Set on your wi- router DNS to 8.8.8.8 (Google DNS server)
• If above does not help, try to upgrade software again
2. Entering AQUOS NET+ is not possible
• Most probable cause may be missing or wrong MAC address
Steps of test validity of MAC address:
1. Press MENU + 1147 to enter factory menu
2. Go to 11 SW Information and press OK (Pic.1)
3. Check item 10 Sraf Valid MAC
4. If there is (OK), it means everything is ok (Pic. 2)
Note: It may take few seconds until “OK” shows after turning TV on.
5. If there is (NG), means either MAC address is missing or is not supported by current SDK (Pic.
3).
In case of NG test result:
1. Check 7 Mac Addr
2. If value is FF:FF:FF:FF:FF:FF – this means MAC was not added during production of main-
board.
Solution to x this issue: Request new MAC addresses from TV manufacturer.
3. If value is dierent than FF:FF:FF:FF:FF:FF – Means current address is not supported by soft-
ware.
Solution to x this issue: Upgrade TV software to the latest version.
Picture 1 Picture 2 Picture 3
To Next Page
Loading...
Need help?
General