OTHER CONVENIENT
FE
A
TURES
Signal setting
There is a choice of 2 different sounds and no
sound on your oven.
To set signal, touch the SET pad twice within 2
seconds and then touch the SIGNAL pad
continuously until you hear desired tone.
Demonstration mode
To demonstrate, touch SELECTATIME, 0 and
then touch START and hold for 3 seconds.
Cooking operations can now be demonstrated
with no power in the oven. The timer will count
down rapidly.
To cancel, touch SELECTATIME, then 0 and
STOP/ CLEAR.
SERVICE CALL CHECK
Please check the following before calling for service!
1. Plug the power cord into a three-pronged electric-outlet. (See page 4)
2. Place one cup of water in a glass measuring cup in the oven and close the door securely.
Operate the oven for one minute on High (100%).
oN seY ?no emoc thgil nevo eht seoD .A
oN seY ?krow naf gnilooc eht seoD .B
(Put your hand over the back ventilation opening.)
C. (For R-21LTF or R-21LVF) Does the "ON" indicator come on? Yes No
oN seY ?toh retaw eht si ,etunim 1 fo dne eht tA .D
If "NO" is the answer to any of the above questions, please check electrical outlet, fuse and/or circuit
breaker. If they are functioning properly, CONTACT YOUR NEAREST SHARP AUTHORIZED SERVICER.
A microwave oven should never be serviced by a "do-it-yourself" repair person.
NOTE: If time is counting down very rapidly, the demonstration mode may be set. To cancel, unplug the
oven from the electrical outlet and replug.
ERROR MODE
Should the error indicator appear in the readout, follow the instructions:
EE Mode Reason Action Required
EE 9 Maximum time is exceeded Check page 11 in the Operation Manual.
Touch STOP/CLEAR pad and reprogram
correctly.
14
To Next Page
Loading...
Need help?
General
