Shinco SPF3-12C User Manual

EN
7
Cooling mode
 When the A/C enters cooling mode automatically or cooling mode is selected after
power ON, the cooling indicator lamp lights up.
 Press Up/Down key to adjust setting temperature (16℃~30℃).
 Press Speed key to choose High/Mid/Low speed.
Fan mode
 When pressing mode key or choosing Fan mode by pressing the remote controller,
the wind indicator lamp lights up.
 Press Speed key to choose High/Mid/Low speed.
 Temperature can’t be set.
Dehumidification mode
 When pressing mode key or choosing dehumidification
mode by pressing the remote controller, t
he
dehu
midification indicator lamp lights up.
 Remove the dehumidification water wedge, insert water
manifold, place the other end of the water manifold int
o
t
he water vessel or drainage passage, as shown in the
right figure.
 After entering the dehumidification mode, if room
tempearture≥17℃ (62℉), the compressor is ON. The
n
c
ontrol as follows: when room temperature ≤15℃ (59℉)
the compressor is OFF; when temperature increases to room temperature≥17℃, the
compressor is started again (in order to protect the compressor, it will be restarted
3min. later).
 In dehumidification mode, the fan is defaulted to run at low speed, and wind speed
c
an’t be adjusted.
 Temperature can’t be set. （Note : when use dehumidify function, should remove
exi
t pipe components, otherwise, it will cause worse dehumidify performance,
and appear “FL” water full alarm ）
Auto mode (for cooling model only)
 When pressing mode key or choosing auto mode by pressing the remote controller,
the auto indicator lamp lights up.
 After choosing Auto mode, operation state is determined by environmental
temperature: when environmental temperature is higher than 25℃, the operation
state is the same as that of cooling mode; when environmental temperature is lower
than 25℃, the operation state is the same as that of fan mode.
Heating mode (for cooling and heating model only)
 When pressing mode key or choosing heating mode by pressing the remote
c
ontroller, the heating indicator lamp lights up.
 Press Up/Down key to adjust setting temperature (16℃~30℃).
 Press Speed key to choose High/Mid/Low speed.
OPERATION METHOD

Shinco SPF3-12C Specifications

General

Brand	Shinco
Model	SPF3-12C
Category	Air Conditioner
Language	English