AS28H Handset / Israel EN / A31008-M2051-B501-1-VU19 / starting.fm / 19.02.2009
6
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and
discharged.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls,
and so that the alarm can be used.
MENU ¢ Settings ¢ OK ¢ Date/Time ¢ OK
¢ Date: ¢ ~ (enter the day, month and year in 6-digit format) ¢ OK
¢ Time: ¢ ~ (enter hours and minutes in 4-digit format) ¢ OK (display message: Saved)
¢ a (press and hold to return to idle status)
Display in idle status
Once the phone is registered and the time set,
the idle display is shown as in this example.
Activating/deactivating the handset
Press and hold the end call key a to activate or deactivate the handset.
If you place a deactivated handset in the base s
tation or charging cradle, it will automat-
ically activate.
Your phone is now ready for use!
If you have any questions about using your phone, please read the tips on troubleshooting
("Questions and answers"
¢ page 9) or contact our Customer Care team ¢ page 9.
Please note
◆ After the first battery charge and discharge you may replace your handset in the
base station or charging cradle after every call.
◆ Always repeat the charging and discharging procedure if you remove the batteries
from the handset and reinsert them.
◆ The batteries may warm up during charging. This is not dangerous.
◆ After a while, the charge capacity of the batteries will decrease for technical
reasons.
Please note
When entering the time and dat
e, you can move the position of an entry to the left
or right by pressing the control button up or down.
¤ Place the handset in the base station or charging cradle for
eight hours.
¤ Then remove the handset from the base station or charging cradle
and do not replace it until the batteries are fully discharged.
8 h
To Next Page
Loading...
Need help?
General