3/13
Building Technologies Division CC1N7130en
Infrastructure & Cities Sector 22.08.2013
Commissioning notes
x When commissioning the plant or when doing maintenance work, make the
following safety checks:
a) Burner startup with flame detector
Lockout at the end of safety time
b) Burner startup with flame detector
exposed to extraneous light
Lockout after no more than 40
c) Burner operation with simulated loss of
flame; for that purpose, darken the flame
detector during operation and maintain
Repetition followed by lockout at
the end of safety time (TSA)
Standards and certificates
Conformity to EEC directives
- Electromagnetic compatibility EMC (immunity)
Identification code to EN 230:
Service notes
x Use the KF8885 / KF8833 / KF8840 service adapters for short periods of time only
Life cycle
Burner controls has a designed lifetime* of 250,000 burner startup cycles which, under
normal operating conditions in heating mode, correspond to approx. 10 years of usage
(starting from the production date given on the type field).
This lifetime is based on the endurance tests in the standard EN 230.
A summary of the conditions has been published by the European Control
Manufacturers Association (Afecor) (
www.afecor.org).
The designed lifetime is based on use of the burner controls according to the
manufacturer’s Data Sheet. After reaching the designed lifetime in terms of the number
of burner startup cycles, or the respective time of usage, the burner control is to be
replaced by authorized personnel.
* The designed lifetime is not the warranty time specified in the Terms of Delivery
Disposal notes
The unit contains electrical and electronic components and must not be disposed of
together with domestic waste.
Local and currently valid legislation must be observed.
To Next Page
Loading...
Need help?
General
